[. . . ] Scrap the appliance in compliance with local regulations on waste disposal, taking it to a special collection centre; do not leave the appliance unattended even for a few days, since it is a potential source of danger for children. For further information on the treatment, recovery and recycling of this appliance, contact your Declaration of conformity . This appliance is intended for storing food and is manufactured in conformity with European regulation (EC) No. This product has been designed, manufactured and marketed in compliance with: - the safety objectives of Low Voltage Directive 2006/95/EC; - the protection requirements of EMC Directive 2004/108/EC . [. . . ] Whenever possible, the back of the appliance should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions. The appliance should be left for 2 hours after installation before it is turned on, in order to allow the refrigerant to settle. WARNING: Keep ventilation opening, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the the manufacturer. WARNING: Do not use electrical appliance inside the food storage compartments of the appliance, unless they are of the recommended WARNING: Do not damage the refrigerant circuit. Servicing This product should be serviced by an authorised engineer, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. € • • • Child Safety • This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely. Young children should be supervised to ensure that they do not play with the appliance. € • At the End of the Appliance Life Before discarding an old PRODUCT, switch off and disconnect it from the power supply, Cut off and render any plug useless. Keep Away from Danger It is inadvisable that the refrigerator is placed near any volatilizable or combustible such as gas, petrol, alcohol, lacquer and banana oil, etc. Moving When fixed or moved, the refrigerator can not be set horizontally or declinet to more than 45° or upsidedown. Cautions • Water contained in food or getting into air inside the refrigerator by opening doors may form a layer of frost inside, It will weaken the refrigerator when the frost is thick, while it is more than 2mm thick, you should defrost. Before defrosting, take the food, the ice tray and the shelf out into the cold storing chamber temporarily then set the knob of the temperature regulator to position"0"(where the compressor will stop working) and leave the door open until ice and frost dissolve thoroughly deposited at the bottom of the freezer chamber, wipe off the water with soft cloth. , In the case of speeding up the defrosting, you may put a bowl of warm water (about 50 C )into the freezer chamber, and be sure to set the knob of the temperature regulator to original position after defrosting. € It's inadvisable to heat the freezer chamber directly with hot water or hair dryer while defrosting to prevent deformation of the inner case. € It's also inadvisable to scrape of ice and frost or separate food from the containers which have been congealed together with the food with sharp tool or wooden bars, so as not to damage the inner casing or the surface of the evaporator. € If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required. Care and maintenance Replacing lamps When replacing the lamp, proceed as follows: - Unplug the appliance from the mains. - Replace the lamp with a new one, maximum watts recommened in the label inside the appliance next to the lamp. - Put the lamp cover back on and wait 5 minutes before plugging the appliance back into the mains. [. . . ] There may be insufficient clearance between the refrigerator and the surfaces Immediately both sides and above. wHEN THE DEFROSTING WATER OVERFLOWS INSIDE THE REFRIGERATOR AND ONTO THE FLOOR. WHEN CONDENSATION FORM ON THE OUTSIDE OF THE REFRIGERATOR Condensation may form on the outside when the humidity is high such as during a wet season. This is the same result as the condensation formed when chilled water is poured into a glass. [. . . ]